|
There are currently no product reviews.
 ;
Again a great job. I never been disilluted from them! Clear scheme, complete and very good for repairing!
;
Great manual just what I needed, great service as always, thanks.
;
Great quality complete service manual! complete parts list and drawings. Thanks!
;
Great quality complete service manual! complete parts list and drawings. Thanks!
;
Very good quality, prompt response. This website has reasonable prices and wide range of manuals that are hard to find.
CHAPTER 8 PAPER DECK
7. Routing the Lifter Cable 1) Check to make sure that the lifter drive shaft and the lifter are held in position by a hex wrench [1] and screwdrivers [2], respectively. 2) Secure the lifter fixing plate [3] in place to the lifter with two screws. 3) Hook the lifter cable on the pulley [4]. 4) Hook the ball of the lifter cable on the pulley [5] of the lifter drive shaft; then, wind it along the pulley groove about 1.5 times. (At this time, be sure to keep the lifter cable taut so that the long screwdrivers are slightly pulled up.) 5) Secure the pulley in place to the lifter drive shaft with two set screws [6]. 6) Secure all pulleys to the lifter drive shaft; then, measure the distance between the bottom plate of the compartment to the top face of the lifer to make sure that the lifter is level.
[4]
[3] [4]
(rear) [5] [6] [3]
[3] [6] [5] [1] [3]
Figure 8-337
[2]
COPYRIGHT © 1999 CANON INC.
CANON imageRUNNER 400/330 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
8-35
 $4.99 IR330 CANON
Parts Catalog Parts Catalog only. It's available in PDF format. Useful, if Your equipment is broken and You need t…
|
