RICOH IS430
Owner's Manual

Image Scanner User's Manual

¡ Turning the power on
Caution:
Confirm that the DIP switches on the rear of the scanner are in the original position as shown right. If the settings have been changed, correct the settings, otherwise the scanner may not work correctly. Note : Switch 3 may be in the ON position if you are not using SCAM � if this is the case, the setting is correct.
Original position

«
1 2 3 4 5 6 7 8
ON

OFF : with SCAM ON : without SCAM

1. Push the power switch at the front of the scanner. 2. Confirm that the switch is set as shown in the illustration. If you want to turn the power off, push the power switch again.
Power On Power Off

¡ Initializing the scanner
Generally, you do not have to initialize the scanner. However, when you change the SCSI ID or DIP switch settings while the scanner is on, you do need to initialize the scanner. You can initialize the scanner not only by turning the power off and on but also by pushing the reset switch at the rear of the scanner. 1. Push the reset switch using a tapered tool such as the tip of a mechanical pencil. 2. Confirm that the four indiators light for a few seconds. This means the scanner is intializing.

-8-

03_IS430-BODY

Page 8

97.5.8, 5:35 PM

PageMaker 5.0J