|
There are currently no product reviews.
 ;
Exellent manual ,it was in great condition,and got all the info i expected,5 stars!!
;
I searched the Internet exhaustively for this manual and Owner-Manuals was the least expensive...but provided an excellent reproduction within 4 hours. Very satisified.
 ;
Rapid and precise delivery. Good print. On the spot.
;
available for me the service manual is in order!
thanks
;
This is exactly the thing you need to service this box. The manual is complete and the quality of the scan is good. I recommend this!
INC
Making of self-made tool
the main PCB of repair parts. The making procedure is shown below. Make a self-made tool according to this procedure. This tool is the same one that was made for AF-S24-85/3.5-4. Use the same main PCB that was used for AF-S24-85/3.5-4G.
JAA78851-R.3617.A
� To inspect and adjust the output waveform of MR encoder, it is necessary to make a self-made tool by using
Use this range. Main PCB
â� Remove the mounted parts/elements (condenser, transistor, IC, etc.) from both sides of PCB, within the range of the left dotted lines . Do not remove the connector.
Connector
� Cut off the PCB along the dotted lines.
� Solder the wires on the PCB pattern at 4 parts as shown left.
GND MR-A
MR-B
VCC (5.0V)
- T2ï½¥ AF-S DX17-55/2.8G -
|
