|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Superb! It's the original manual. We can now use our old calculator with its full function.
;
This is a very well written and comprehensive manual. It answered all our queries.
;
Excellent copy that was delivered within 12 hours and solved my problem.
 ;
I did not have the manual for a Whirl Pool gas dryer, therefore I purchased it from Owner-manuals. This is exactly what I needed. Thank you for the service.
;
I was so pleased to get the owner`s manuel within one hour! Thanks again.
Regards
Werner
Connection
s Power cable connection
2WARNING
To prevent fire caused by a short in the wiring, connect a fusible link or breaker nearby the battery�s positive terminal.
FUSE(25A)
POWER IN
SPEAKER OUTPUT
BRIDGED LEFT
RIGHT
SPEAKER LEVEL INPUT LEFT RIGHT A SPEAKER LEVEL INPUT A B L R B
GND
BATT
A P.CON(REMOTE)
25
B
Round terminal (Small) Round terminal (Medium)
Power terminal
Terminal cover Battery cable
Power control cable CENTER UNIT Ground cable
Round terminal (Large) Protective Fuse
Battery
Power terminal Connect to their respective terminals the power control cable, power supply cable, and ground cable, all of which pass through the associated terminal cover. Once the connections are complete, place the cover on the terminal section. Wiring � If a buzzing noise is heard from the speakers when the engine is running, connect a line noise filter (optional) to each of the battery cable. � Do not allow the cord to directly contact the edge of the iron plate by using Grommets. � Connect the ground cable to a metal part of the car chassis that acts as an electrical ground passing electricity to the battery�s negative - terminal. Do not turn the power on if the ground cable is not connected. � Be sure to attach a protective fuse into the battery cable close to the battery. Use a protective fuse having a capacity that is about 10 A higher than the maximum current drawn by the amplifier. � Use vehicle-type (fire-resistant) power supply wiring cable for the battery cable and the ground cable. The current capacity of the power supply wiring cable should be about 10 A higher than that of the protective fuse capacity (which means about 20 A higher than the maximum current drawn by the amplifier). � When more than one power amplifier are going to be used, use a power supply wiring cable and protective fuse of greater current-handling capacity than the total maximum current drawn by each amplifier. Example: One Power Amplifier Is Used Model Maximum Current Protective Fuse Cross-sectional Area of Wiring Drawn Cable (AWG) KAC-648 22 A 30 A � 1 [15 A � 2] 3 mm2 (AWG 12) or greater � 1
15 A 30 A 15 A 15 A 15 A
7
|
|
|
> |
|
