|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
Attaching the Rubber Packing
(if it is not already attached to the camera main unit)
� If rubber packing is not attached, it is necessary to first correctly attach the rubber packing before attaching the main unit cover. In this case, attach by following the procedure described below.
Dome Cover
Rubber Packing
Dome Cover (KA-C76)
Rubber Packing
Rubber Packing
Tab
Cross-section
Groove
Pipe
Dome Cover Rubber Packing Pipe
1. Attach the rubber
packing in the position shown in the illustration. Make sure that the rubber packing is parallel to the pipe.
2. Align the tab on the
dome cover with the groove on the pipe and fit the dome cover.
3. Move the rubber packing upward
as shown in the cross-section diagram. When performing this, do not remove the installed dome cover from the pipe. If the dome cover is removed, the rubber packing will drop inside the pipe and it will not be possible to re-attach the dome cover. If the rubber packing is not correctly attached, the dust- and drip-proof performance of the dome cover cannot be guaranteed.
VICTOR COMPANY OF JAPAN, LIMITED
is a registered Trademark owned by VICTOR COMPANY OF JAPAN, LTD. is a registered Trademark in JAPAN, the U.S.A., the U.K. and many other countries. © 2002 VICTOR COMPANY OF JAPAN, LIMITED Printed in Japan LWT0089-001A
|
|
|
> |
|
