Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
So usefull to make my installation a breeze. 5 stars on quality.
Text excerpt from page 3 (click to view)
WIRE CODES
WOOFER INSTALLATION
TWEETER INSTALLATION
Figure 6
3
Tweeter level +3dB Tweeter level 0dB
�
Figure 3 Figure 4
1
ROTATE TO AIM ANGLED TWEETER TO LISTENER
+
1
SLIDE UP OR DOWN TO ADJUST TWEETER ANGLE
2
KX00
+0db +3dB
TIGHTEN NUT AND WASHER TO LOCK THE ANGLE SETTINGS
+ IN +W+T-
2
Fasten the midrange through the plastic grille tray with the screws and clips provided. Press the metal mesh in place in the tray.
Mounting the tweeter using the I-Mount surface-mounting kit.
To amplifier speaker output
To woofer
To tweeter
Aim the tweeter at the listening position by sliding the stud in the groove on the back of the tweeter cup and rotating the entire assembly in the mounting surface. Lock the tweeter in place using the small retaining nut and the large plastic mounting nut.
Figure 2 Connect the speakers and amplifier to the crossover as shown.
Figure 5
1 2
Mounting the tweeter using the I-Mount flush-mounting kit.