|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
;
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
;
The manual was very helpfull, it answerdes all my questions, and i was surprized to find the original manual on this site! Big thumbs uP:)
 ;
helpful manual.good service.Quick response.will use again
;
Speedy confirmation to my order , with elaborate instructions .
Item Email , received immediately as desired by me.
A Pleasant & Satisfying Transaction.
INSTALLATION
Figure 5A. Mounting the tweeter using the I-Mount� flush-mounting kit. Figure 6. Mounting the tweeter using the I-Mount� surface-mounting kit. blk
CONNECTIONS
Open the crossover housing by placing your fingers between the terminals and the top cover, and gently pulling off the cover. Using screws or a wire tie, mount the crossover through the holes provided. Observing proper polarity, connect the speakers and amplifier as shown in 7A and 7B. Replace the cover when you are finished making connections and adjustments. Figure 7A. Wiring connections on the crossover network (shown with cover on). Infinity Kappa component crossovers include a �Custom Contour�� adjustment. Custom Contour, if enabled, will reduce the midrange output from the system, resulting in more perceived bass and high frequency. You may choose the setting that best suits your listening perference. The default position is �Flat� . Figure 7C. Enable Custom Contour by moving the jumper (located in the upper-left corner, inside the crossover housing) to connect the two left pins. Defeat Custom Contour by moving the jumper to connect the two right pins.
blk red
1) push in 2) turn
� +
1 2
� +
red
2ohm
p/s 050
5.4uF
6.8uF
2ohm
Contour Flat
Contour Flat
- IN +
- WF +
- TW + -3dB
0.15mH
Figure 5B. Aiming the tweeter at a desired listening position.
0.22mH
Flat
3
ROTATE TO AIM ANGLED TWEETER TOWARD LISTENER. To AMPLIFIER SPEAKER OUTPUTS Red To WOOFER Blk To TWEETER
Contour
1
SLIDE SCREW UP OR DOWN TO ADJUST TWEETER ANGLE.
Figure 7B. Locating wiring connections on the 50.5cs woofer. Other woofers are wired similarly.
2
TIGHTEN NUT AND WASHER TO LOCK ANGLE SETTINGS.
4
SECURELY TIGHTEN THE LARGE HAND NUT.
Big Lug = Small Lug =
-3-
|
|
|
> |
|
