|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
So usefull to make my installation a breeze. 5 stars on quality.
;
very helpful, the information in these manuels are very detailed
;
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.00 of store credit for Your review.
;
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.00 of store credit for Your review.
;
Good copy and great customer service! There was some confusion with my order and it was resolved promptly!
Making the Connections
Switching the Power On and Off
Once the connections have been completed, turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices. 1. Make sure that all volume controls on the KC-60 and connected devices are set to 0. 2. Turn on all the devices connected to the KC-60�s input jacks (CH 1 through CH 3 and AUX IN). 3. Turn on the KC-60. 4. Switch on any equipment connected to the KC-60�s LINE OUT or SUBWOOFER OUT jacks. 5. Adjust the volume levels for the devices. 6. Before switching off the power, lower the volume on each of the devices in your system and then TURN OFF the devices in the reverse order to which they were switched on. * This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is required before the unit will operate normally. For protection from sudden big sound, always make sure to have the volume level turned down before switching on power. Even with the volume all the way down, you may still hear some sound when the power is switched on, but this is normal, and does not indicate a malfunction.
About the Volume-level Settings
In order to get optimum sound from the KC-60 when performing, set the volume as described below. 1. Operate the CH 1 through CH 3 volume knobs to adjust the volume level for channels 1 through 3.
fig.11
Adjust the volume balance for channels 1 through 3 at this time. * To adjust the volume level of equipment connected to the AUX IN jacks, use the controls on such equipment. 2. Adjust the LOW and HIGH knobs to obtain the tone you want. 3. Use the VOLUME knob to adjust the overall volume level.
fig.12
* If the sound is distorted, lower the CH 1 through CH 3 volume knobs, VOLUME knob and/or the volume knobs for devices connected to the input jacks (CH 1 through CH 3 and AUX IN).
9
|
|
|
> |
|
