|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very well done!!!!! congratulations. It was a bit longer than usual the wiating time even if it was on time (in 24 hours).
;
Last week I bought a second hand BAUKNECHT TRK4850 DRYER. It is a professional machine with many programs and switch options. I feared it would be a huge quest to find a manual. I was delighted when I found owner-manuals.com. After payment I received the file to download the next day already. The quality is great. I am very happy. Thanks!
but kindly the distributions of the operating programs not find in the owners manual,can you help me to understand the operating programs instructions thank you
;
Very good copy, very readable and easy transaction as always.
;
It is perfect, exactly what we needed. It's like the paper version but less clutter.
 ;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
5.
Loosen the T-bolts for the stand and mount the legs on the stand. Install the legs as shown in the figure so that the ends of the legs protrude by about 2 cm.
Extend the leg by about 2 cm.
Mount the legs on the stand.
T-bolt
6. 7. 8. 9.
Tighten the T-bolts to secure the legs to the stand. Lift the KD-120 and place the stand and the four legs upright. Adjust the angle of the head surface so that it�s at a right angle to the floor. Use the included drum key to loosen the bracket bolts you tightened in step 3, and adjust the angle of the KD-120 pad so that the head surface is at a right angle to the floor. Install the included beater on your kick pedal. * Using a beater made of felt may result in wear to the felt. Use the special included beater or a plastic beater as the beater for the kick pedal. Mount the kick pedal on the KD-120. * Make sure there is about 1 cm of space between the two to keep the kick pedal�s chain (or belt) from touching the hoop of the KD-120 pad during play. Also, if the kick pedal has no under-plate, then arrange the stand�s plate section at a right angle to the floor.
Space apart by about 1 cm.
10.
f
90�
If the kick pedal has no under-plate, then arrange the stand�s plate section at a right angle to the floor.
11.
Make any fine adjustments necessary and tighten the stand brackets to make sure the KD120 is secure on the stand. Make sure the KD-120�s four legs and heel portion of the kick pedal is securely on the floor by loosening the stand�s T-bolts and adjusting the length of the legs. Adjust the striking point for the beater. Normally the beater�s striking point is adjusted to fall at the center of the head. Adjust the striking point so that it doesn�t extend beyond the cushion on the back of the head. Moving the striking point closer to the sensor increases the sensitivity, so carry out fine adjustment to suit your preferences.
12.
6
|
|
|
> |
|
