|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This service manual helped me to repair my PIONEER. Iam very satisfied, that I found it here.
Even the price of manual was not so high that person would not be able to spend a few money.
But that is very worth spent money. Thanks
 ;
Excellent quality service manual. Quick processing, fair prices. Love to do business again. Thank you!!!
;
Excellent service manual, the only known point of note is the alignment of improvability scanned pages within the pdf page. The resolution is good.
;
I was very glad recieving the service manal from You. Additionaly very fast. Extremaly nice servicing. Thanks very mach! Now my GX-220 working better, than it was made. Alexander from Moscow, Russia/
;
Sweet! I won the item on eBay and couldn't adjust the geometry or even keep a steady picure. This guide has the full schematics (not available anywhere else as far as I could tell), and was a bargain for the wealth of knowledge it contains. I hooked it up to my testing equipment, tweaked a few potentiometers and got it playing videogames in no time. Thanks!
KD-32FS130/36FS130
SECTION 2: SET-UP ADJUSTMENTS
The following adjustments should be made when a complete realignment is required or a new picture tube is installed. These adjustments should be performed with rated power supply voltage unless otherwise noted. Set the controls as follows unless otherwise noted: VIDEO MODE: Pro PICTURE CONTROL: Normal BRIGHTNESS CONTROL: Normal
Perform the adjustments in order as follows: 1. Beam Landing 2. Convergence 3. Focus 4. Screen (G2) 5. White Balance Note Test Equipment Required: 1. Color Bar Pattern Generator 2. Degausser 3. DC Power Supply 4. Digital Multimeter
2-1. BEAM LANDING
Before beginning adjustment procedure: 1. Feed in the white pattern signal.
6. Switch over the raster signal to red and blue and con�rm the condition. 7. When the position of the de�ection yoke is determined, tighten it with the de�ection yoke mounting screw. 8. If landing at the corner is not right, adjust by using the disk magnets.
Adjustment Procedure
1. Input a raster signal with the pattern generator. 2. Loosen the de�ection yoke mounting screw, and set the purity control to the center as shown below: Purity Control
Purity control corrects this area.
3. Turn the raster signal of the pattern generator to green. 4. Move the de�ection yoke backward, and adjust with the purity control so that green is in the center and red and blue are even on both sides.
Disk magnets or rotatable disk magnets correct these areas (a-d).
a c
b d
Deflection yoke positioning corrects these areas. b
Blue Red Green
d a c
5. Move the de�ection yoke forward, and adjust so that the entire screen becomes green.
KD-32FS130/36FS130
29
|
|
|
> |
|
