|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
 ;
Mi spiace per non poter scrivere in inglese... ma sono veramente soddisfatto del servizio offerto. Grazie..!!
;
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
;
Quick site processing. A complete and very useful manual with all details. Thank you!
;
Das Service Manual war von der ersten bis zur letzten Seite sehr informativ und hilfreich. Die Darstellung aller Teile war klar und der Text gut lesbar.
Vielen Dank, das war nicht der letzte Download bei ownner-manuals.com.
2
ENGLISH
General settings � PSM
You can change PSM (Preferred Setting Mode) items listed in the table that follows.
Indication [Range]
BAS*1 (bass) Adjust the bass. [�06 to +06] TRE*1 (treble) Adjust the treble. [�06 to +06] FAD*2 (fader) Adjust the front and rear speaker balance. [R06 to F06] BAL*3 (balance) Adjust the left and right speaker balance. [L06 to R06] LOUD*1 (loudness) Boost low and high frequencies to produce a well-balanced sound at low volume level. [LOUD ON or LOUD OFF] SUB.W*4 (subwoofer) Adjust the subwoofer output level. [00 to 08] VOL (volume) Adjust the volume. [00 to 30 or 50*5] *1 When you adjust the bass, treble, or loudness, the adjustment you have made is stored for the currently selected sound mode (C-EQ) including �USER.� *2 If you are using a two-speaker system, set the fader level to �00.� *3 This adjustment cannot affect the subwoofer output. *4 This takes effect only when a subwoofer is connected. Displayed only when �L/O MODE� is set to �WOOFER� (see page 13). *5 Depending on the amplifier gain control setting. (See page 13 for details.)
1 2
Select a PSM item.
3
Adjust the PSM item selected.
Ex.: When �DIMMER� is selected
4 5
Repeat steps 2 and 3 to adjust other PSM items if necessary. Finish the procedure.
12
|
|
|
> |
|
