|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
As Always you can find here manuals even of difficult TV scheme which are scan in almost perfect way.clear and fast!!!!!
Great work thanks!
;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
 ;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
KDC-225/225MR/2025
TEST MODE
1. How to enter test mode
While holding the FM key and PRESET 6 keys, reset the unit. All display segments light up when the test mode is entered.
6. AUDIO function � Audio-related specifications
� A short press of the Q key initiates the audio adjustment mode. � Pressing the OPEN/CLOSE key on the remote controller initiates the audio adjustment mode. � Continuous holding of a remote control key is inhibited. � Bass, Middle and Treble are adjusted in 3 steps of -8 / 0 / +8 with the Track Up/down keys (default is 0). � Balance is adjusted in 3 steps of Left L15 / 0 / R15 Max with the Track Up/down keys (default is 0). � Loudness : OFF
2. How to exit from test mode
Reset the unit. Turning ACC off, power off, momentary power down or panel detaching does not terminate the test mode.
3. Initial status in the test mode
� Sources : ALL OFF (STAND BY) � Display : All segments were lit. � Volume : -10dB (displayed as �30�) � Loudness : OFF � CRSC : OFF regardless of the presence of switching function. � Aux : ON
7. MENU function � Menu-related specifications
� A short press of the PLAY/PAUSE key initiates the Menu mode. � Pressing the DNPP key on the remote initiates the Menu mode. � Continuous holding of a remote control key is inhibited.
4. TUNER function � Forced switching of K3I
Each press of the Preset 6 key in Tuner mode should switch K3I from AUTO�Forced Wide�Forced Middle�Forced Narrow�AUTO. The initial status is AUTO and the display shows these modes as follows. � AUTO : A � Forced Wide : M � Forced Middle : M � Forced Narrow : N
8. OTHER � Special display when the display is all on
Pressing the Preset keys while the power is ALL OFF displays the following information.
[PRESET 1] [PRESET 2] [PRESET 3] Version display (Month/Day/Hour/Minute) ALL segment light up for FL display Short press : Display CD operation time. Long press/hold : Clear CD operation time [PRESET 5] Short press : Display CD ejection count. Long press/hold : Clear CD ejection count. [FM] ROM correction version. If not mounting ROM correction chip set display shows ROM No___
� RDS check
PCON is power off when RDS data (�RDS test�) received for TUNER mode.
5. CD function � Test mode specifications of the CD receiver
� Each press of the Track Up key jumps to the following track numbers : No. 9�No. 15�No. 10�No. 11�No. 12�No. 13�No. 22 �No. 14�No. 9 (The cycle restarts from here.) � Each press of the Track Down key jumps to the previous track number to the track being played. � When the number of total tracks of disc is nine or less, unit playback from a track 1. � When the media to CD-DA, unit playback from track No. 28 by key operation of preset 1 key.
7
|
|
|
> |
|
