|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very fast and perfect delivery. Clear and well scanned. A lot of work professionally realized.
Again thak you a lot
 ;
This manual is accurate and of high quality. It is only volume 2 of the service manual. This is schematic, parts lists, and exploded mechanical drawings. The theory of operation and the diss-assembly instructions are in volume 1. The unit can be tricky to dis-assemble portions of so the volume 1 manual can be important. The product description of the manual is accurate but it does not say anything about volume 1 and the image of the front page does clearly say Volume 2.
;
Wellll again thank you very much fast and effective. Clear and well done for such an old TV!!!!
;
It has all the information you will need to fix it. The main circuit diagram is only A4 but being a PDF, you can print it to any size - I did it on two sheets of A3 and it didnt lose any detail - just made it readable when pinned up above the bench. I've found the fault, just need to buy some obscure bits to get it going again!
I cant fault the process, I paid for the manual in the morning and it was ready to download by lunch time.
;
Very good copy in a 54 pages PDF archive. This is my sixth purchase here. :)
KDC-MP225,MP4026/G KDC-W4527/G/GY/Y,W427Y
COMPONENTS DESCRIPTION
� SWITCH UNIT (X16-2640-xx/2642-xx/2652-xx)
Ref. No. IC1 IC2 Q1 Q2 Q3 Application / Function LCD driver Remote control IC KEY scan detector key illumination SW key illumination SW Drive for LCD unit Receiving for the remote control unit key scan start at base gose �L�. Lights up for RED key illumination when base voltage level goes �H� Lights up for GREEN key illumination when base voltage level goes �H� Operation / Condition / Compatibility
� ELECTRIC UNIT (X25-9980-xx/9982-xx/X34-3172-70)
Ref. No. IC1 IC2 Application / Function System microcomputer Electronic volume & N.C.MPX Operation / Condition / Compatibility Control for TUNER unit, CD mechanism, volume & tone, LCD driver and external CD changer unit Control for source selector, volume & tone, and FM multiplex detector. Power supply for the units (Bu5V, Audio8V, FM+B, AM+B, P-con and ANT-con) SW1 1.5~3.0V 3.5~5.0V IC3 Power supply IC 7.0V~ SW2 2.0~3.0V 4.0V~ IC4 IC6 IC7 IC8 IC9 Q1 Audio power amp IC Muting control IC RDS decoder Reset IC Switching regulator Serge detection When backup voltage become less than 24V output is �H� When BU voltage supplied output is �L� / Q2 Q3 Q4 Q21,24 Q22 Q23 Q41 Q101 Q151 Q201 Backup detection When BU voltage not supplied or momentary power down is detected output is �H� ACC detection SW 5V AVR SW IC control SW Buffer amp DSI driver turns off / When panel assy is pull off, cut off the supply to panel 5V AVR. Buffer amp Noise buffer amp When ACC voltage supplied output is �L� When base voltage is �L� Q4 is ON Servo regulator Servo SW Power supply IC controller Switching regulator control SW Composite signal buffer When base voltage level is �L� DSI LED is light up / When base voltage level is �H� DSI LED Audio ON Audio P-con ON Audio P-con, P-ant ON OUT Illumination, FM ON Illumination, AM ON OUT
Amplifier for audio signal to derive for 4channel speakers (50W maximum for each channel) Control for timing for mute Decode for RDS signal When detection voltage goes below 3.5V or less Reset IC output change to �L� signal Power supply for CD mecanism unit When backup voltage become more than 24V output is �L� (momentary power down) /
4
|
|
|
> |
|
