|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great to have extra resources for Service Manuals, Now days you can really not trouble shoot efficiently without one , Wayne at IRIONS TV & ELECTRONICS REPAIR Clearwater , Fl. 33755 727-446-7955
 ;
For five bucks you can barely buy a hamburger. Or for the same five bucks you can buy a service manual. Much more useful. (and better for your health, depending on where you buy your hamburgers).
Yes, there are free manual sites out there, but if they don't have what you want, you have to pay.
And five bucks isn't much. Not for full specs, schematics and adjustment and parts replacement procedures.
My only criticism is that grayscale illustrations aren't well rendered, but I've seen worse.
Schematics and text are clear.
I'll be happy to purchase from here again.
Mike
[email protected]
;
Impressively thorough. Even the simple operators manual helped me "fix" one of the 2 CD players in the unit. This unit reads CD's from the top so they should be installed in the magazines "upside down" from typical CD players. The CD player service manual helped me unjam a stuck carriage because somebody transported the box laying down loaded with CD's. A little lens cleaning & the player now works well! Thanks for you help at a great price! Joe
;
I was skeptical at first but later found the manual to be good quality for the price. It took a couple hours to receive the email with the download link, well worth the wait. Thanks.
;
very helpful, I could not have cleaned motherboard and replaced the main fan without it
KDC-MP225,MP4026/G KDC-W4527/G/GY/Y,W427Y
COMPONENTS DESCRIPTION
� SWITCH UNIT (X16-2640-xx/2642-xx/2652-xx)
Ref. No. IC1 IC2 Q1 Q2 Q3 Application / Function LCD driver Remote control IC KEY scan detector key illumination SW key illumination SW Drive for LCD unit Receiving for the remote control unit key scan start at base gose �L�. Lights up for RED key illumination when base voltage level goes �H� Lights up for GREEN key illumination when base voltage level goes �H� Operation / Condition / Compatibility
� ELECTRIC UNIT (X25-9980-xx/9982-xx/X34-3172-70)
Ref. No. IC1 IC2 Application / Function System microcomputer Electronic volume & N.C.MPX Operation / Condition / Compatibility Control for TUNER unit, CD mechanism, volume & tone, LCD driver and external CD changer unit Control for source selector, volume & tone, and FM multiplex detector. Power supply for the units (Bu5V, Audio8V, FM+B, AM+B, P-con and ANT-con) SW1 1.5~3.0V 3.5~5.0V IC3 Power supply IC 7.0V~ SW2 2.0~3.0V 4.0V~ IC4 IC6 IC7 IC8 IC9 Q1 Audio power amp IC Muting control IC RDS decoder Reset IC Switching regulator Serge detection When backup voltage become less than 24V output is �H� When BU voltage supplied output is �L� / Q2 Q3 Q4 Q21,24 Q22 Q23 Q41 Q101 Q151 Q201 Backup detection When BU voltage not supplied or momentary power down is detected output is �H� ACC detection SW 5V AVR SW IC control SW Buffer amp DSI driver turns off / When panel assy is pull off, cut off the supply to panel 5V AVR. Buffer amp Noise buffer amp When ACC voltage supplied output is �L� When base voltage is �L� Q4 is ON Servo regulator Servo SW Power supply IC controller Switching regulator control SW Composite signal buffer When base voltage level is �L� DSI LED is light up / When base voltage level is �H� DSI LED Audio ON Audio P-con ON Audio P-con, P-ant ON OUT Illumination, FM ON Illumination, AM ON OUT
Amplifier for audio signal to derive for 4channel speakers (50W maximum for each channel) Control for timing for mute Decode for RDS signal When detection voltage goes below 3.5V or less Reset IC output change to �L� signal Power supply for CD mecanism unit When backup voltage become more than 24V output is �L� (momentary power down) /
4
|
|
|
> |
|
