|
Who's Online
There currently are 5599 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
;
This manual is very helpfull to use the Power Supply. All technical information has been available.
For service use the circuit diagrams are very good.
Thanks .
;
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
Indication, [Range]
General settings � PSM
You can change PSM (Preferred Setting Mode) items (except �SID�) listed in the table that follows.
ENGLISH
[�06 to +06] Adjust the bass. TRE*1 (treble), [�06 to +06] Adjust the treble. FAD*2 (fader), [R06 to F06] Adjust the front and rear speaker balance. BAL*3 (balance), [L06 to R06] Adjust the left and right speaker balance. LOUD*1 (loudness), [LOUD ON or LOUD OFF] Boost low and high frequencies to produce a well-balanced sound at low volume level. SUB. W*4 (subwoofer), [00 to 08] Adjust the subwoofer output level. VOL (volume), [00 to 30 or 50*5] Adjust the volume. *1 When you adjust the bass, treble, or loudness, the adjustment you have made is stored for the currently selected sound mode (C-EQ) including �USER.� *2 If you are using a two-speaker system, set the fader level to �00.� *3 This adjustment cannot affect the subwoofer output. *4 This takes effect only when a subwoofer is connected. *5 Depending on the amplifier gain control setting. (See page 16 for details.)
BAS*1 (bass),
1 2
Select a PSM item.
Ex.: When you select �DIMMER�
3
Adjust the PSM item selected.
4 5
Repeat steps 2 and 3 to adjust the other PSM items if necessary. Finish the procedure.
14
|
|
|
> |
|