JVC KDLX300
Owner's Manual

Manual preset
ENGLISH
You can preset up to 6 stations in each band (FM1, FM2, FM3 and AM) manually. Ex: Storing an FM station of 88.3 MHz into the preset number 1 of the FM1 band

4

Repeat the above procedure to store other stations into other preset numbers.

Notes: � A previously preset station is erased when a new station
is stored in the same preset number. � Preset stations are erased when the power supply to the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again.

1

Select the band (FM1).
1 Press SOURCE to select the tuner as the source. 2 Press BAND repeatedly to select the FM1 band.

Tuning into a preset station
You can easily tune into a preset station. Remember that you must store stations first. If you have not stored them yet, see �Storing stations in memory� on pages 9 and 10.

2

Tune into a station of 88.3 MHz.
Press ¢ to tune into stations of higher frequencies. Press 4 to tune into stations of lower frequencies.

1

Select the band.
1 Press SOURCE to select tuner as the source. 2 If necessary, press BAND repeatedly to select the band.

Each time you press the button, the band changes as follows:

3

Press and hold the number button (in this example, 1) for more than 2 seconds.

FM1

FM2

FM3

AM

2

Select the number (1 � 6) for the preset station you want.

Band number and �MEMO� appear alternately for a while.

When using this unit in an area other than North or South America: You need to change the AM/FM channel intervals. See �To change the AM/FM channel intervals � AREA� on page 19.

10