|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very helpfull information and I highly recommend this source for needed information about your products.
 ;
More than pleased with my prurchase, very good product for the price.
;
This is a good quality scan of the service manual which includes an assembly diagram, block diagram, schematic, and parts list. Exactly what is needed to repair my KR-V55R receiver.
;
Excellent concise manual. All needed information was included. Typeface and diagrams were clear. Very fair price considering what others are charging. Many thanks
;
Response is a little slow- I had to wait 12 hours to receive download link but it says that it may take up to 24hrs.
Manual is old and was not produced in PDF- scanned copy is exellent.
Overall- value for money- I recommend
KD-S587
Removing the feed motor ass�y (See Fig.10)
Prior to performing the following procedure, remove the CD mechanism control board, the front bracket (loading motor) and the CD mechanism ass�y. 1. Remove the two screws K and the feed motor ass�y.
FD screw Part n Feed motor ass�y Part O
K
Pickup unit
FD gear
Pickup unit
Fig.10
Removing the pickup unit (See Fig.10 and 11)
*Prior to performing the following procedure, remove the CD mechanism control board, the front bracket (loading motor), the CD mechanism ass�y and the feed motor ass�y. 1. Detach the FD gear part of the pickup unit upward. Then remove the pickup unit while pulling out the part n of the FD screw. ATTENTION: When reattaching the pickuap unit, reattach the part o of the pickup unit, then the part n of the FD screw. 2. Remove the screw L attaching the nut push spring plate and the pickup mount nut from the pickup unit. Pull out the FD screw. Fig.11
FD screw
L
Nut push spring plate Pickup mount nut
Pickup unit
Removing the spindle motor (See Fig.12 and 13)
Prior to performing the following procedure, remove the CD mechanism control board, the front bracket (loading motor), the CD mechanism ass�y and the feed motor ass�y. 1. Turn up the CD mechanism ass�y and remove the two springs p on both sides of the clamper arms. Open the clamper arm upward. 2. Turn the turn table, and remove the two screws M and the spindle motor.
p
p
Fig.12
Spindle motor
M
M
Fig.13
1-10
|
|
|
> |
|
