JVC KDS711R
Owner's Manual

SOUND ADJUSTMENTS
Adjusting the sound
You can adjust the sound characteristics to your preference.

2

Adjust the level.
To increase the level.

1

Select the item you want to adjust.
Each time you press the button, the adjustable items change as follows: To decrease the level.

BAS
(bass)

TRE
(treble)

FAD
(fader)

VOL
(volume)

LOUD
(loudness)

BAL
(balance)

Equalization pattern changes as you adjust the bass or treble.

Indication
BAS

To do:
Adjust the bass.

Range
�06 (min.) | +06 (max.) �06 (min.) | +06 (max.) R06 (Rear only) | F06 (Front only) L06 (Left only) | R06 (Right only) LOUD ON | LOUD OFF

Note: Normally the control dial works for volume adjustment. So you do not have to select �VOL� to adjust the volume level.

TRE

Adjust the treble.

Using the Sound Control Memory (SCM)
You can select and store a preset sound adjustment suitable for each playback source. (Advanced SCM)

FAD*

Adjust the front and rear speaker balance. Adjust the left and right speaker balance. Boost low and high frequencies to produce a wellbalanced sound at low volume level. Adjust the volume.

BAL

Selecting and storing the sound modes
Once you select a sound mode, it is stored in memory. It will be recalled every time you select the same source and will be shown on the display. A sound mode can be stored for each of the following sources � FM1, FM2, FM3, AM and CD. � If you do not want to store the sound mode separately for each playback source, but want to use the same sound mode for all the sources, see �To cancel Advanced SCM� on page 21.

LOUD

VOL

00 (min.) | 50 (max.)

* If you are using a two-speaker system, set the fader level to �00.�

Select the sound mode you want.
Each time you press the button, the sound mode changes as follows:

BEAT

SOFT

POP

SCM OFF

17

ENGLISH