|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
;
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
 ;
Clear and easy to read. All details as expected. Price acceptable , and quick delivery.
;
Quick response and exactly what I was looking for and at a great fair price!
;
5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
ENGLISH
Changing the display mode while listening to an FM station
You can change the initial indication on the display to station name (PS NAME), station frequency (FREQ) or clock time (CLOCK) while listening to an FM RDS station. � See also �Changing the general settings (PSM)� on page 21.
Setting the TA volume level
You can preset the volume level for TA Standby Reception. When a traffic programme is received, the volume level automatically changes to the preset level. � See also �Changing the general settings (PSM)� on page 21.
1 Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears on the display. 2 Press ¢ or 4 to select �TA VOL (volume).� 3 Turn the control dial to set to the desired volume. You can set it from �VOL 00� to �VOL 50.� 4 Press SEL (select) to finish the setting.
1 Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears on the display.
2 Press ¢
or 4 (display mode).�
to select �DISPMODE
3 Turn the control dial to set to the desired indication
(�PS NAME�, �FREQ� or �CLOCK�).
4 Press SEL (select) to finish the setting.
Note: By pressing DISP (display), you can change the display while listening to an FM RDS station only. Each time you press the button, the following information appears on the display:
Automatic clock adjustment
When shipped from the factory, the clock built in this unit is set to be readjusted automatically using the CT (Clock Time) data in the RDS signal. If you do not want to use automatic clock adjustment, follow the procedure below. � See also �Changing the general settings (PSM)� on page 21.
Station name (PS NAME) Station frequency (FREQ) Programme type (PTY) Clock
1 Press and hold SEL (select) for more than 2
seconds so that one of the PSM items appears on the display. 2 Press ¢ or 4 to select �AUTO ADJ (adjustment).� 3 Turn the control dial counterclockwise to select �OFF.� Now automatic clock adjustment is canceled. 4 Press SEL (select) to finish the setting. To reactivate clock adjustment, repeat the same procedure and select �ON� in step 3 by turning the control dial clockwise.
� Then, the display goes back to the original indication in several seconds.
Note: You must stay tuned to the same station for more than 2 minutes after setting �AUTO ADJ� to �ON.� Otherwise, the clock time will not be adjusted. (This is because the unit takes up to 2 minutes to capture the CT data in the RDS signal.)
14
|
|
|
> |
|
