JVC KD-S790
Owner's Manual

ENGLISH

Manual preset
You can preset up to 6 stations in each band (FM1, FM2, FM3, and AM) manually. Ex.: Storing FM station of 88.3 MHz into the preset number 1 of the FM1 band.

4

Repeat the above procedure to store other stations into other preset numbers.

1

Select the band (FM1 � 3, AM) you want to store FM stations into (in this example, FM1).
Each time you press the button, the band changes as follows:

Notes: � A previously preset station is erased when a new station is stored in the same preset number. � Preset stations are erased when the power supply to the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again.

Tuning in to a preset station
You can easily tune in to a preset station. Remember that you must store stations first. If you have not stored them yet, see �Storing stations in memory� on pages 11 and 12.

FM1

FM2

FM3

AM

2

Tune in to a station (in this example, of 88.3 MHz).
To tune in to stations of higher frequencies

1

Select the band (FM1 � 3, AM).
Each time you press the button, the band changes as follows:

To tune in to stations of lower frequencies

FM1

FM2

FM3

AM

2 3
Press and hold the number button (in this example, 1) for more than 2 seconds.

Select the number (1 � 6) for the preset station you want.

Note: You can also use the 5 (up) or � (down) button on the unit to select the next or previous preset stations. Each time you press the 5 (up) or � (down) button, the next or previous preset station is tuned in.

�P1� flashes for a few seconds.

12