JVC KDSC800R
Owner's Manual

Manual preset
You can preset up to 6 stations in each band (FM1, FM2, FM3, and AM) manually. Ex.: Storing FM station of 88.3 MHz into the preset number 1 of the FM1 band.

4

Repeat the above procedure to store other stations into other preset numbers.

1

Select the band (FM1 � 3, AM) you want to store stations into (in this example, FM1).
Each time you press the button, the band changes as follows:

Notes: � A previously preset station is erased when a new station is stored in the same preset number. � Preset stations are erased when the power supply to
the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again.

FM1

FM2

FM3

AM

Tuning in to a preset station
You can easily tune in to a preset station. Remember that you must store stations first. If you have not stored them yet, see �Storing stations in memory� on pages 8 and 9.

2

Tune in to a station (in this example, of 88.3 MHz).
To tune in to stations of higher frequencies

1

Select the band (FM1 � 3, AM).
Each time you press the button, the band changes as follows:

To tune in to stations of lower frequencies

FM1

FM2

FM3

AM

2 3
Press and hold the number button (in this example, 1) for more than 2 seconds.

Select the number (1 � 6) for the preset station you want.

Note: You can also use the 5 (up) or � (down) button on the unit to select the next or previous preset stations. Each time you press the 5 (up) or � (down) button, the next or previous preset station is tuned in.

�P1� flashes for a few seconds.

9

ENGLISH