|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Absolutely perfect! I've been trying to understand how to use all or at least some of the features of the receiver and especially the remote.
;
Copy of genuine owners/operators manual, very useful
;
The manual was a perfect match and was exactly what I was looking for. I'm very satisfied with my purchase.
;
Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
;
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
SOUND ADJUSTMENTS
Performing the basic sound settings
You can set the speaker output balance, subwoofer output level, and input level of each source. � There is a time limit in doing the following procedure. If the setting is canceled before you finish, start from step 1 again.
2
Adjust the level.
To adjust fader and balance�Fad, Bal: Make these two adjustments at the same time. � If you are using a two-speaker system, set the fader level to �00.� � Press 5 (up) or � (down) to adjust the fader. � Press ¢ or 4 to adjust the balance.
1
Press SEL (select) repeatedly to show one of the basic sound setting (SEL) screens.
SEL
Each time you press the button, the adjustable items change as follows:
DSP
iEQ
Basic sound settings
Fad/Bal
To adjust subwoofer output�Sub Out: This takes effect only when a subwoofer is connected.
ATT
Canceled
Vol Adj
BBE
Sub Out
To increase the level. To decrease the level.
� For DSP mode settings, see pages 32 to 34. � For iEQ (sound mode) settings, see pages 35 and 36. Indication Fad To do: Range
Adjust the front R06 (Rear only) and rear speaker | balance. F06 (Front only) Adjust the left L06 (Left only) and right speaker | balance. R06 (Right only) Adjust the subwoofer output level and cutoff frequency level. Make sounds natural. Adjust and store the input level of each source. 00 (min.)
|
You can also set an appropriate cutoff frequency level according to the subwoofer connected. � Press ¢ or �Mid,� or �High.� Low: 4 to select �Low,�
Bal
Sub Out
08 (max.) Low/Mid/High BBE Off, BBE 1, BBE 2, BBE 3 �05 (min.)
|
BBE Vol Adj
Frequencies higher than 50 Hz are cut off to the subwoofer. Mid: Frequencies higher than 80 Hz are cut off to the subwoofer. High: Frequencies higher than 115 Hz are cut off to the subwoofer.
+05 (max.)
37
ENGLISH
|
|
|
> |
|
