|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good copy in a 54 pages PDF archive. This is my sixth purchase here. :)
;
Another excellent buy! File too clear and explanatory.
 ;
A manual hard to find. It was very helpful to restore my device.
;
I am very grateful for this manual. Without it could not repair my receiver.
;
excellent work as always you do cheap, fast net and clean. you do an incredible service......thanks!
KD-SX992R/KD-SX921R
Feed Section
Is the voltage output at IC541 pin "53" 5V or 0V? NO Is the wiring for IC541 (90) ~ (100) correct? NO YES NO YES YES Is 5V present at IC501 pin "20"? YES Check the vicinity of IC541. Is 6V or 3V present at IC501 "10" and "11"? NO Check IC501. Check the feed motor connection wiring. NO Check CD 9V and 5V.
Is 4V present at both sides of the feed motor? YES Check the feed motor.
Focus Section
When the lens is moving: NO Check the circuits in the vicinity of IC501 pins "15" ~ "18". YES YES Check the pickup and its connections.
4V
Does the S-search waveform appear at IC501 pins "6" and "7"?
Spindle Section
Is the disk rotated? YES YES Does the RF signal appear at TP1? YES Is the RF waveform at TP1 distorted? YES Proceed to the Tracking section NO Check the circuits in the vicinity of IC521 "16" the pickup Check the spindle motor and its wiring. Check the vicinity of IC501. NO Is 4V present at IC501 pins "8" and "9" ? NO Is 4V present at IC541 pin "55" ? YES NO Check IC521 and IC541.
NO
Tracking Section
When the disc is rotated at first: YES Approx. 1.2 V Is the tracking error signal output at IC521 "12"? YES Check IC541. Check the circuit in the vicinity of IC521 pins "2" ~ "12". YES Check the pickup and its connections.
1-22
|
|
|
> |
|
