|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It took about 24-hours after my payment before I was able to get to the download. Apparently, payment processing is not 100% automated. That is no big deal, just be aware of that going in.
After I got to it, it was in good shape, easy to read, etc. Not some cheap FAX copy looking thing.
Also, this site was the cheapest I found. Another Plus!
 ;
Good price, very legible manual, exactly what I needed -- but had to wait a day to actually get the download of the manual. Would have preferred to download it immediately after payment rather than waiting for someone to "process" my order. I was surprised that I had to wait that long.
;
As the only source for this manual it rather rank quite high since it is well scanned and perfectly readable.
;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
KD-SX992R/KD-SX921R
Feed Section
Is the voltage output at IC541 pin "53" 5V or 0V? NO Is the wiring for IC541 (90) ~ (100) correct? NO YES NO YES YES Is 5V present at IC501 pin "20"? YES Check the vicinity of IC541. Is 6V or 3V present at IC501 "10" and "11"? NO Check IC501. Check the feed motor connection wiring. NO Check CD 9V and 5V.
Is 4V present at both sides of the feed motor? YES Check the feed motor.
Focus Section
When the lens is moving: NO Check the circuits in the vicinity of IC501 pins "15" ~ "18". YES YES Check the pickup and its connections.
4V
Does the S-search waveform appear at IC501 pins "6" and "7"?
Spindle Section
Is the disk rotated? YES YES Does the RF signal appear at TP1? YES Is the RF waveform at TP1 distorted? YES Proceed to the Tracking section NO Check the circuits in the vicinity of IC521 "16" the pickup Check the spindle motor and its wiring. Check the vicinity of IC501. NO Is 4V present at IC501 pins "8" and "9" ? NO Is 4V present at IC541 pin "55" ? YES NO Check IC521 and IC541.
NO
Tracking Section
When the disc is rotated at first: YES Approx. 1.2 V Is the tracking error signal output at IC521 "12"? YES Check IC541. Check the circuit in the vicinity of IC521 pins "2" ~ "12". YES Check the pickup and its connections.
1-22
|
|
|
> |
|
