|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
;
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Very good!
;
Great Job!!! clear and efficient as always!!
it is really nice to have peple that are doing such a good work!!!!!
;
I must admit, I was very skeptical... $4.99 for a 74 page service manual. I've seen some very poorly scanned manuals on the Internet, but this one is VERY good quality! Even when zooming into 500%. Great Deal!
;
Very good detail, Quick service response. A useful service manual with all details. I recomend this service.
KD-SX998R,KD-SX997R
3.3 Troubleshooting 3.3.1 Feed section
Is the voltage output at IC621 pin "40" 5V or 0V? YES Is 4V present at both sides of the feed motor? YES Check the feed motor.
3.3.2 Focus section
NO
Is the wiring for IC681 pin 27? NO
YES Is 3.3V present at IC681 pin "20"? YES Check the vicinity of IC621. YES Check the feed motor connection wiring.
NO Check CD 8V and 5V.
NO
Is 6V or 2V present at IC681 "4" and "5"? NO Check IC601.
When the lens is moving: 4V
Does the S-search waveform appear at IC681 pins "8" and "9"?
NO
Check the circuits in the vicinity of IC681 pins "8","9"and"15". YES
YES
Check the pickup and its connections
3.3.3 Spindle section
Is the disk rotated? YES Does the RF signal appear at RF test point? YES Is the RF waveform at RF test point distorted? YES Proceed to the Tracking section
3.3.4 Tracking section
NO
Is 4V present at IC681 pins "6" and "7"? YES
NO
Is 4V present at IC621 pins "41" ? YES Check the vicinity of IC561.
NO
Check the spindle motor and its wiring NO Check the circuits in the NO vicinity of IC681 "19"~ "24" or the pickup
Check IC621 and IC681.
When the disc is rotated at first:
YES
Approx. 1.2V Is the tracking error signal output at IC601 "11"?
Check the circuit in the vicinity of IC501 pins "2"~"7".
YES
Check the pickup and its connections
YES Check IC621.
(No.49819)1-25
|
|
|
> |
|
