|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is the correct service manual of SHARP RX-100H(BK) DAT.
;
The ervice manual for my 1982 Kenwood KR-1000 receiver is great! Full detail on all circuits with part number detail. I will definately be ordering more manuals for my other vintage equipment! Order was fulfilled quickly! Very efficient ordering process! Thnaks for your help! Great site!
 ;
Everything in the manual was excellent except for a couple of pictures of specific areas in the unit that were a little dark. Owners Manuals re-sent the pdf file & the problem was corrected. Excellent product! George
;
Thanks for offering this item at such a good price. Proved handy in identifying the part I was looking for my set.
Thanks again.
;
This is the original manufacturers service manual, with detailed info on the circit boards, explosion drawings of all parts in assembly order, and tuning instructions. The only thing missing is the information on the dimensions of the various drive belts. mail me if you need them. gcrossman_at_aol.com
KDV-C810/C820/C830 /C840/C860
qSetting for the unit condition as follows. POWER ON : STOP MPEG UNIT
No. 1 ITEM 27MHZ REFERENCE CLOCK INPUT SETTINGS -
ADJUSTMENT
OUTPUT SETTINGS Connect a Frequency counter between 27MHz test point to GND.
SETTINGS STOP (POWER ON)
ALIGNMENT POINT CT551
ALIGN FOR 27MHz±0.1KHz
FIG A
MPEG UNIT (COMPONENT SIDE VIEW)
27MHz TEST POINT 27MHz Reference Clock CT551
GND
Fig. A
Frequency counter
Notes.
About repair of a laser pickup with service. Change with a laser pickup single article and adjustment cannot be performed. A service part is supplied in a pickup unit (with in VM1, VM2, PHT2 and SW4). If you need change to spindle motor (VM1) and feed sensor (PHT2) you can order to pickup unit. About the handling after repair (for transportation) Please after repair for the units you must be internalized elevator mechanism of most below position (for magazine pack eject position), and always attach CAUTION CARD and STEPPED SCREW (for transportation). In order to make an elevator mechanism downed, please carry out in the following procedure (this model not included test mode). * Shut off a power supply within 2 seconds after magazine pack discharge.
12
|
|
|
> |
|
