|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It is perfect, exactly what we needed. It's like the paper version but less clutter.
 ;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
Initial Settings
Adjusting initial settings
Setting the time
English Español Deutsch Français Italiano Nederlands
This is used to set the time on the unit�s clock display. 1 Press AUDIO to select the time. Press AUDIO until the time appears in the display.
Initial settings lets you perform initial set up of different settings for this unit. 1 Press SOURCE and hold until the unit turns off. 2 Press AUDIO and hold until TIME appears in the display. Press AUDIO repeatedly to switch between the following settings:
TIME�FM STEP�AM STEP�AUX
2 Select the portion of the time display you wish to set with 2/3. Pressing 2/3 will select a portion of the clock display:
HOUR�MINUTE
As you select portions of the clock display the portion selected will blink.
Use the following instructions to operate each particular setting. � To cancel initial settings, press BAND. � You can also cancel initial settings by holding down AUDIO until the unit turns off.
3 Select the correct time with 5/�. Pressing 5 will increase the selected hour or minute. Pressing � will decrease the selected hour or minute.
Setting the FM tuning step
The tuning step employed by Seek Tuning in the FM mode can be switched between 100 kHz (preset at the factory) and 50 kHz. 1 Press AUDIO to select FM STEP. Press AUDIO repeatedly until FM 100 appears in the display. 2 Select the FM tuning step with 2/3.
En
16
|
|
|
> |
|
