|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
Section
Audio Adjustments
06
Adjusting loudness
Loudness compensates for deficiencies in the low- and high-sound ranges at low volume. 1 Press AUDIO to select Loud. Press AUDIO until Loud appears in the display. 2 Press 5 to turn loudness on. Loudness level (e.g., Loud Mid) appears in the display. 3 Press 2 or 3 to select the level. Press 2 or 3 until the desired level appears in the display. Low (low)�Mid (mid)�High (high) 4 Press � to turn loudness off. Loud OFF appears in the display.
Adjusting subwoofer settings
When the subwoofer output is on, you can adjust the cut-off frequency and the output level of the subwoofer. 1 Press AUDIO to select the Sub-W2. When the subwoofer output is on, you can select the Sub-W2. Press AUDIO until Sub-W2 80 (Hz) appears in the display. � If the subwoofer setting has been previously adjusted, the frequency of that previously selected will be displayed, such as 50 (Hz) or 125 (Hz). 2 Press 2 or 3 to select cut-off frequency. Press 2 and 50 (Hz) is displayed. Press 3 and 125 (Hz) is displayed. Only frequencies lower than those in the selected range are output from the subwoofer. 3 Press 5 or � to adjust the output level of the subwoofer. Each press of 5 or � increases or decreases the level of the subwoofer (e.g., +6 to �6). Press 5 or � until you see the desired value displayed.
Using subwoofer output
This unit is equipped with a subwoofer output which can be switched on or off. 1 Press AUDIO to select Sub-W1. When the subwoofer controller setting is S.W Control:EXT, you cannot select Sub-W1. Press AUDIO until Sub-W1 appears in the display. 2 Press 5 to turn subwoofer output on. Sub-W1 Normal appears in the display. Subwoofer output is now on. � You can turn off subwoofer output by pressing �. 3 Press 2 or 3 to select the phase of subwoofer output. Press 2 to select reverse phase and Rev. appears in the display. Press 3 to select normal phase and Normal appears in the display.
English Español Deutsch Français Italiano Nederlands
En
27
|
|
|
> |
|
