Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
Text excerpt from page 44 (click to view)
KEH-P7850
7.2 DIAGNOSIS 7.2.1 DISASSEMBLY
- Removing the Case(not shown) 1. Remove the two screws. 2. Remove the Case. - Removing the Cassette Mechanism Module
(not shown)
1. Remove the four screws. 2.Disconnect the connector, and then removing the Cassette Mechanism Module. - Removing the Panel Assy(Fig.1) Remove the two screws.
Disconnect the two connectors.
Disengage the stopper at two locations indicated and remove the Panel Assy.
Panel Assy
Fig.1
- Removing the Tuner Amp Unit(Fig.2) Removing the two screws.
Removing the three screws.
Removing the screw.
Unbend the tabs at two locations indicated by arrow until straight. Remove the Tuner Amp Unit.