|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
5 STARS for FAST DELIVERY, BEST PRICES and QUALITY PRODUCT. Item was exactly as described with superb resolution. Will definitely source all my future requirements from this website. Thanks a lot owner-manual.com!
;
OEM manual provided all schematics, board layouts and component specs necessary to facilitate unit maintenance. All pages were clear and readable.
;
Good condition and quality. Hard to find anywhere in Internet, only on this site.
 ;
Exactly what I needed to be able to bring the amp back to life... will come back to this site the next time I need schematics.
;
Information was accurate and very helpful.
However the continuity made it a little difficult to follow from one page to the next.
2C9
1-6-3 Optical section
(1) Detaching and refitting the exposure lamp Take the following procedure when the exposure lamp is to be replaced. Procedure 1. Remove the original cover or the DP. 2. Remove the two screws holding the upper right cover and then the cover. Remove the contact glass.
Contact glass
Upper right cover
Figure 1-6-29 3. Move the mirror 1 frame to the cutouts of the machine. * When moving the mirror 1 frame, do not touch the exposure lamp nor the inverter PCB. 4. Detach the exposure lamp connector from the inverter PCB and release the wire from three clamps.
Clamps
Connector
Inverter PCB
Figure 1-6-30 5. Remove the two screws holding the exposure lamp and then the lamp. 6. Replace the exposure lamp and refit all the removed parts.
Exposure lamp
Figure 1-6-31
1-6-17
|
|
|
> |
|
