|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
;
The manual was properly scanned and perfectly readable. The only small problem is that I couldn't use my dear Ctrl + F to find a word I needed.
;
Nothing wrong with the manual or the delivery - came to me the same day I ordered it. But afterwards I realized that I ordered the wrong manual. Probably better with the Quick start - version. So maybe it would be better if we could see a list with inhold for each manual before ordering?
 ;
Bought T4850 High End Tuner a few years ago, but i didn't know where all the buttons were used for. So i purchased the owners manual. Perfect! Just what i needed.
;
Bought the used Philips car-radio. No manual! Found on this site a copy of the orginal English manual. I am very happy with it. Now I know how to setup and use my "new" car-radio.
Recommended site for everybody looking for a manual for (older) products!
Using the cooktop
Turning on and off / Regulating
The control knob is used to turn on the burner and to regulate the strength of the flame. Regulating the burners The inner and outer burners are both controlled by one control knob. There is a stop at the 6 o�clock position that requires you to press the knob down while turning it in order to get from the high flame to the low flame zone. ^ To reduce the flames from a high to low setting, turn the control knob counterclockwise until you feel resistance. Press the knob down to pass the stop, then release the pressure and set the cooktop to the desired setting. ^ To increase the flames from a low to high setting, turn the control knob clockwise until you feel resistance. Press the knob down to pass the stop, then release the pressure and set the cooktop to the desired setting.
Turning on ^ To turn on the burner, press the control knob down and turn it counterclockwise to the largest flame symbol. The ignitor will click and ignite the gas. ^ When the flame appears, keep the control knob pressed in for 8-10 seconds to allow the Ignition Safety Control to reach operating temperature. Release the knob. If the flame goes out, repeat the above procedure, keeping the control knob pressed in for a few extra seconds. ^ Release the knob and adjust it to the desired setting.
10
|
|
|
> |
|
