|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
;
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
;
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Very good!
MEASUREMENT OF THE MICROWAVE OUTPUT POWER
Microwave output power can be checked by indirectly measuring the temperature rise of a certain amount of water exposed to the microwave as directed below. Procedure 1. Microwave power output measurement is made with the microwave oven supplied at rated voltage and operated at its maximum microwave power setting with a load of 1,000±5cc of potable water. 2. The water is contained in a cylindrical borosilicate glass vessel having a maximum material thickness of 3 mm and an outside diameter of approximately 190 mm. 3. The oven and the empty vessel are at ambient temperature prior to the start of the test. The initial temperature of the water is 10±2�C(50±3.6�F). It is measured immediately before the water is added to the vessel. After addition of the water to the vessel, the load is immediately placed on the center of the shelf which is in the lowest normal position. 4. Microwave power is switched on. 5. Heating time should be exactly 52 sec.(KOG-36A5) or 47 sec.(KOG-38A5). Heating time is measured while the microwave generator is operating at full power. The filament heat-up time for magnetrons is not included. 6. The initial and final water temperatures are selected so that the maximum defference between the ambient and final water temperature is 5K.
7. The microwave power output P in watts is calculated from the following formula: P = 4187 X � T/t � � T is actual temperature rise. � t is the heating time. The power measured should be 800W(KOG-36A5)±10% or 900W(KOG-38A5)±10%.
CAUTION : 1. Water load should be measured exactly to 1 liters. 2. Input power voltage should be exactly 230 volts as specified. 3. Ambient temperature should be 20±2�C (68±3.6�F)
8
|
|
|
> |
|
