|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I liked the product. I would use their sevices again.
 ;
I Recently purchased yet another Service Manual from Owner-Manuals.com, this time for a Sony EVS700ES/UB Videocassette Recorder. The Manual was available for upload within two hours and is an Extremely Good copy, as some of this I was able to enlarge to get even better detail.
Once Again, Very happy with the result!
;
A good and useful manual. With these, We was abled to isolate and pin point the component that was causing the problem. The total time spent in troubleshooting is very much reduced.
;
The quality of the manual is top. The transfer worked perfect and fast.
No problems at all. Recommendable
;
Very good service for get any documentation. Fast and perfect quality.
KP-53XBR200/61XBR200
RM-Y902 RM-Y902
[GREEN REGISTRATION ADJUSTMENT]
<GREEN CENTER ADJUSTMENT>
1. Select �GRN CENT� with the 1 and 4 keys on the remote control. 2. Use the joystick key on the remote control and adjust the vertical and horizontal section not possible in Main mode. (See item 5 of �Setup for adjustment�.)
GRN CENT
� Marker Movement (A vortex shape as shown below appears when the 1 key on the remote control is held down and when the vortex reaches the upper right it again returns to the center of the screen. Reverse this movement with the 4 key on the remote control.)
<GREEN SKEW>
1. Select �GRN SKEW� with the 1 and 4 keys on the remote control. 2. Adjust with the joystick keys on the remote control so that there is no slope on the vertical and horizontal center line.
GRN SKEW
5. Shift to Rough Adjustment mode with the [9] key on the remote control. 6. Change the FIHP value with the joystick key so that the tip of the peak is in the center of the screen as shown below.
FIHP
<H-PHASE ADJUSTMENT(COHP, FIHP, TPHP)>
1. Select �COHP� with the 1 and 4 keys on the remote control and check that the data is �0�. 2. Select �F1HP� with the 1 and 4 keys on the remote control. 3. Shift to Fine Adjustment mode with the 9 key on the remote control. 4. Move the joystick key to increase the peak vertically in the + direction to form the peak as shown below. * The speed at which changes in the peak occurs
FIHP
7. Select �TPHP� with the 1 and 4 keys on the remote control. The marker will now appear so use the 1 and 4 keys on the remote control to adjust to position the center of the marker in the screen center. 8. Shift to Fine Adjustment mode with the 9 key on the remote control and return the peak section data.
TPHP
<GREEN PINCUSHION>
is slow so increasing the data for the peak will make it easier to see.
1. Shift to Rough Adjustment mode with the 9 key on the remote control. 2. Select �GRN PIN� with the 1 and 4 keys on the remote control. 3. Adjust with the joystick keys on the remote control so that the upper and lower horizontal lines changes from a crooked to nearly a straight shape. (A slope on the line is okay.)
GRN PIN GRN PIN
� 49 �
|
|
|
> |
|
