|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I am very pleased with the service manual for my RT-909. This was an easy purchase and great procuct, and much cheaper than other venues i had looked at. This web site is now listed in my favorites list. KEEP UP THE GOOD WORK. THANKS. J. BROWN
;
A very well written and easy to understand manual.
;
There was no problem at all.After paying i had to wait only a few hours,than i could
download the manual in best pdf-quality.
Thank You !
 ;
I found this service manual to be complete in every detail except for troubleshooting charts. It would be helpful if it had a set of troubleshooting charts; however it is a very good manual otherwise and for the price it is very well worth it.
;
Complete manual included schematics layouts and alignment procedure, clear to read and magnify, extremely pleased with manual and owner manual . com's service
KP-XA43M31/XA43M61/XA43M91
RM-967
GREEN HORIZONTAL SYMMETRICAL PIN DISTORTION ADJUSTMENT
GREEN VERTICAL 4TH ORDER DISTORTION ADJUSTMENT
1. Adjust GH MPIN to correct pin distorton at both edges of the centre section. 2. Use GH PIN to correct pin distortion at both edges of the screen. 3. While tracking adjust GH MPIN and GH PIN so that the PIN of vertical lines on the entire screen have no bowing. 4. If there is asymmetrical distortion after adjustments, readjust GH MBOW and GH SBOW while tracking.
1. By using GV 4 PIN, 4th-Order distortion of the horizontal lines at the top & bottom can be corrected. Since there is no 4SBO for vertical correction, there will be a slight imbalnace, but adjust the registration to eleiminate any distortion.
GV 4PIN
M PIN PIN
GREEN VERTICAL TRAPEZOIDAL DISTORTION ADJUSTMENT
1. Adjust GV SSKW so that the tilt of the horizontal lines at the top and bottom of the screen are symmetrical. 2. Adjust GV MKEY so that there is no tilt for the middle section. 3. Adjust GV KEY so that there is no tilt at the top and bottom of the screen. 4. While tracking adjust GV MKEY and GV KEY, so that there is no tilt over the entire screen. 5. If the tilt is unbalanced after GV MKEY and GV KEY have been adjusted, readjust GV SSKW.
GH MBOW
GH PIN
GH SBOW
GH MPIN
GV SSKW
GREEN VERTICAL WAVE (3RD-ORDER) DISTORTION ADJUSTMENT
1. Check the screen at the top & bottom, and look for any 2nd or 3rd order waveform distortion of horizontal lines. Correct with GV WAVE. 2. While tracking adjust GV WAVE and GV KEY, if here are any KEY distortion.
MKEY KEY
GV WAVE
GV KEY
GV SSKW
GV KEY
GV MKEY
� 37 �
|
|
|
> |
|
