|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is the correct service manual of SHARP RX-100H(BK) DAT.
;
The ervice manual for my 1982 Kenwood KR-1000 receiver is great! Full detail on all circuits with part number detail. I will definately be ordering more manuals for my other vintage equipment! Order was fulfilled quickly! Very efficient ordering process! Thnaks for your help! Great site!
 ;
Everything in the manual was excellent except for a couple of pictures of specific areas in the unit that were a little dark. Owners Manuals re-sent the pdf file & the problem was corrected. Excellent product! George
;
Thanks for offering this item at such a good price. Proved handy in identifying the part I was looking for my set.
Thanks again.
;
This is the original manufacturers service manual, with detailed info on the circit boards, explosion drawings of all parts in assembly order, and tuning instructions. The only thing missing is the information on the dimensions of the various drive belts. mail me if you need them. gcrossman_at_aol.com
KRC-17G/YA/YG, 194A/G/YA/YG, 266LA/LG/RG KRC-27YA/YG, 2904YA/YG, 294A/G/YA/YG
ADJUSTMENT
No ITEM INPUT SETTINGS RECEIVER SETTINGS ALIGNMENT POINTS ALIGN FOR
FM SECTION
1
SD
98.1MHz 0 dev 35dBµ(ANT input)
TEST MODE: ON FM 98.1MHz
Preset "1" key, and preset "6" key
While holding preset "1" key, press and hold preset "6" key for a few seconds. "ADJ OK" is good. "ADJ NG" is not good.
AM SECTION
(1)
SD
990 kHz 0% mod 35dBµ(ANT input)
TEST MODE: ON AM 990 kHz
Preset "1" key, and preset "6" key
While holding preset "1" key, press and hold preset "6" key for a few seconds. "ADJ OK" is good. "ADJ NG" is not good.
CASSETTE DECK SECTION
[1]
HEAD HEIGHT
SCC-1659
TAPE PLAY
Head Height Screw
1) During FWD transport adjust F and F ' so that line A of 2LINE TAPE passes through the center of the head shield plate (core center area) 2) During RVS transport adjust R and R ' so that line B of 2LINE TAPE passes through the center of the head shield plate (core center area) 3) After the alignment above, reverse the transport direction and check the FWD alignment again. If it is deviated, perform alignment again. (Tape used : SCC-1659,manufactured by A-BEX)
[2]
HEAD AZIMUTH
TCC-153 10kHz
Connect an AC voltmeter and oscilloscope to SP outputs. TAPE PLAY
Head Azimuth Screw
Adjust the azimuth for each L ch/R ch or FWD/RVS becomes maximum.
TEST MODE : ON TEST MODE : OFF
While holding the "FM" key and preset "6" key, reset the unit. Reset the unit.
TAPE SPEED
(2-LINE TAPE)
B
HEIGHT (FWD)
F
'
R
'
A (FWD)
HEIGHT (RVS)
B
HEIGHT/AZIMUTH (FWD)
F R
HEIGHT/AZIMUTH (RVS)
A
(RVS)
5
|
|
|
> |
|
