|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This service manual helped me to repair my PIONEER. Iam very satisfied, that I found it here.
Even the price of manual was not so high that person would not be able to spend a few money.
But that is very worth spent money. Thanks
 ;
Excellent quality service manual. Quick processing, fair prices. Love to do business again. Thank you!!!
;
Excellent service manual, the only known point of note is the alignment of improvability scanned pages within the pdf page. The resolution is good.
;
I was very glad recieving the service manal from You. Additionaly very fast. Extremaly nice servicing. Thanks very mach! Now my GX-220 working better, than it was made. Alexander from Moscow, Russia/
;
Sweet! I won the item on eBay and couldn't adjust the geometry or even keep a steady picure. This guide has the full schematics (not available anywhere else as far as I could tell), and was a bargain for the wealth of knowledge it contains. I hooked it up to my testing equipment, tweaked a few potentiometers and got it playing videogames in no time. Thanks!
KRC-17G/YA/YG, 194A/G/YA/YG, 266LA/LG/RG KRC-27YA/YG, 2904YA/YG, 294A/G/YA/YG
ADJUSTMENT
No ITEM INPUT SETTINGS RECEIVER SETTINGS ALIGNMENT POINTS ALIGN FOR
FM SECTION
1
SD
98.1MHz 0 dev 35dBµ(ANT input)
TEST MODE: ON FM 98.1MHz
Preset "1" key, and preset "6" key
While holding preset "1" key, press and hold preset "6" key for a few seconds. "ADJ OK" is good. "ADJ NG" is not good.
AM SECTION
(1)
SD
990 kHz 0% mod 35dBµ(ANT input)
TEST MODE: ON AM 990 kHz
Preset "1" key, and preset "6" key
While holding preset "1" key, press and hold preset "6" key for a few seconds. "ADJ OK" is good. "ADJ NG" is not good.
CASSETTE DECK SECTION
[1]
HEAD HEIGHT
SCC-1659
TAPE PLAY
Head Height Screw
1) During FWD transport adjust F and F ' so that line A of 2LINE TAPE passes through the center of the head shield plate (core center area) 2) During RVS transport adjust R and R ' so that line B of 2LINE TAPE passes through the center of the head shield plate (core center area) 3) After the alignment above, reverse the transport direction and check the FWD alignment again. If it is deviated, perform alignment again. (Tape used : SCC-1659,manufactured by A-BEX)
[2]
HEAD AZIMUTH
TCC-153 10kHz
Connect an AC voltmeter and oscilloscope to SP outputs. TAPE PLAY
Head Azimuth Screw
Adjust the azimuth for each L ch/R ch or FWD/RVS becomes maximum.
TEST MODE : ON TEST MODE : OFF
While holding the "FM" key and preset "6" key, reset the unit. Reset the unit.
TAPE SPEED
(2-LINE TAPE)
B
HEIGHT (FWD)
F
'
R
'
A (FWD)
HEIGHT (RVS)
B
HEIGHT/AZIMUTH (FWD)
F R
HEIGHT/AZIMUTH (RVS)
A
(RVS)
5
|
|
|
> |
|
