|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very fast and perfect delivery. Clear and well scanned. A lot of work professionally realized.
Again thak you a lot
 ;
This manual is accurate and of high quality. It is only volume 2 of the service manual. This is schematic, parts lists, and exploded mechanical drawings. The theory of operation and the diss-assembly instructions are in volume 1. The unit can be tricky to dis-assemble portions of so the volume 1 manual can be important. The product description of the manual is accurate but it does not say anything about volume 1 and the image of the front page does clearly say Volume 2.
;
Wellll again thank you very much fast and effective. Clear and well done for such an old TV!!!!
;
It has all the information you will need to fix it. The main circuit diagram is only A4 but being a PDF, you can print it to any size - I did it on two sheets of A3 and it didnt lose any detail - just made it readable when pinned up above the bench. I've found the fault, just need to buy some obscure bits to get it going again!
I cant fault the process, I paid for the manual in the morning and it was ready to download by lunch time.
;
Very good copy in a 54 pages PDF archive. This is my sixth purchase here. :)
KRC-17G/YA/YG, 194A/G/YA/YG, 266LA/LG/RG KRC-27YA/YG, 2904YA/YG, 294A/G/YA/YG
ADJUSTMENT
No ITEM INPUT SETTINGS RECEIVER SETTINGS ALIGNMENT POINTS ALIGN FOR
FM SECTION
1
SD
98.1MHz 0 dev 35dBµ(ANT input)
TEST MODE: ON FM 98.1MHz
Preset "1" key, and preset "6" key
While holding preset "1" key, press and hold preset "6" key for a few seconds. "ADJ OK" is good. "ADJ NG" is not good.
AM SECTION
(1)
SD
990 kHz 0% mod 35dBµ(ANT input)
TEST MODE: ON AM 990 kHz
Preset "1" key, and preset "6" key
While holding preset "1" key, press and hold preset "6" key for a few seconds. "ADJ OK" is good. "ADJ NG" is not good.
CASSETTE DECK SECTION
[1]
HEAD HEIGHT
SCC-1659
TAPE PLAY
Head Height Screw
1) During FWD transport adjust F and F ' so that line A of 2LINE TAPE passes through the center of the head shield plate (core center area) 2) During RVS transport adjust R and R ' so that line B of 2LINE TAPE passes through the center of the head shield plate (core center area) 3) After the alignment above, reverse the transport direction and check the FWD alignment again. If it is deviated, perform alignment again. (Tape used : SCC-1659,manufactured by A-BEX)
[2]
HEAD AZIMUTH
TCC-153 10kHz
Connect an AC voltmeter and oscilloscope to SP outputs. TAPE PLAY
Head Azimuth Screw
Adjust the azimuth for each L ch/R ch or FWD/RVS becomes maximum.
TEST MODE : ON TEST MODE : OFF
While holding the "FM" key and preset "6" key, reset the unit. Reset the unit.
TAPE SPEED
(2-LINE TAPE)
B
HEIGHT (FWD)
F
'
R
'
A (FWD)
HEIGHT (RVS)
B
HEIGHT/AZIMUTH (FWD)
F R
HEIGHT/AZIMUTH (RVS)
A
(RVS)
5
|
|
|
> |
|
