|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I am only search for 5 Minute, by it in 5 Minutes to and get ist in few ours! Best i found in the Internet and my Amplifer is repaired as well! Thank you
 ;
Readable text and good copy. Very much needed if you wish to do some repairs on this fine old unit.
;
Fint forløb med levering af manualen. Kvaliteten af skanningen betegnes som middel
;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
5
6
7
8
A
For Diagnosis
For PRO-141FD
Terminal panel ELT
1 2
Remove the two screws. (BPZ30P080FTB) (KRP-600M only) Remove the two hexagon headed screws. (ABA1382)
2
�2
Terminal panel MTR
For KRP-600M
2
�2
1
1
B
Support bracket MTR
3 4 5
Remove the four screws. (PMB30P060FNI) Temporarily tighten one of the screws that was removed in Step 3. Disconnect the flexible cable from the MAIN Assy.
4
3
3
5 3
MAIN Assy I/O Assy
C
3
6 7
Remove all the cables that are connected to the I/O Assy from their clamps. Remove the cables that are connected to the CN1201 connector from their clamps.
6
6 A 6
CN1201
7 7
D
Note: In a case where the ambient temperature is 35 °C or less You can reverse the I/O Assy in Step 8 without removing the cables from their clamps in Step 7 above, if you detach the CN1201 connector from the I/O Assy and remove the cables connected to the connector from Clamp A.
8
Detach the I/O Assy with support bracket MTR attached. Reverse the I/O Assy in the direction shown in the photo below:
9
Hook support bracket MTR onto the temporarily tightened screw then reconnect the flexible cable to the MAIN Assy.
9
E
8
I/O Assy
Support bracket MTR
I/O Assy
F
PRO-141FD
5 6 7 8
181
|
|
|
> |
|
