|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
 ;
Rapid, clear well done as all the scheme I downloaded from this site. Great job very functional and very useful
;
Great copy of the manual, has all information required for servicing,
;
I work at an authorized service center and I can tell if a manual is as it should be. This one is. It may be a scan, but a very good one at that. The interesting part for me was the curcuit diagram which was scanned at high quality, making it as good as the original. I will definitely be back as a customer. I need not say this, but I will: the price was the best. Thank you owner-manuals.com .
;
really a very good manual even sometimes the quality is no so good as before still very readible and very very useful!
KS-AX7300
SECTION 2 Disassembly method
CAUTION: If electricity is connected during disassembly, it must be a no load current. If it is load current, be sure to attach a heat sink to the power-amp IC. This will be damaged if the above precautions are not followed, as it does not have a sub heat sink attached to it. 2.1 Removing the bottom cover (see Fig. 1) (1) From the bottom side of the main unit, remove the 4 screws A retaining the bottom cover. (2) Then remove the 6 screws B retaining the bottom cover. (3) Remove the bottom cover.
B
Bottom cover
A B
Fig.1 2.2 Removing the Main board (see Fig. 2 to 8) (1) Remove the bottom cover from the main unit. (2) Loosen and remove the 2 screws C retaining the top plate on the main unit. (Stoppers are attached to the backs of the C screws so that they cannot be removed easily.)
A
Top plate
C
C
Fig.2 (3) Remove the 6 volume knobs on top of the control panel. If it cannot be pulled out easily, insert a scale or suitable lever between the base of the volume knob and the control panel so that the volume knob is raised a little above the surface and then remove it. (Be careful when inserting a lever etc. not to scratch the surface of the control panel).
Volume knob
D
Control panel Switch knob
D
(4) Remove the 4 screws D retaining the control panel. Then detach the control panel and the switch knobs.
Fig.3
Volume knob Scale or suitable lever Control panel
(Side view)
Fig.4
(No.49808)1-3
|
|
|
> |
|
