|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent copies.
I will use "Owner Manual" again a second time.
 ;
Very good manual for Technics SL 303. Manuale molto utile.
;
About one hour after checkout, the manual was available for download. Clear reading and detailed. Thanks
;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
KS-FX473R/KS-FX470R
Pinch-roller (R) assembly S support plate C washer A arm spring (b) Shaft Pinch-roller (F) assembly
D
A arm spring (a) Shaft
FF roller
Playback head
Remove the P arm spring (r) from the chassis.
Remove the P arm spring (f) from the chassis.
P arm spring (r)
P arm spring (f)
Fig.2
Removing the playback head (See Fig.2)
Prior to performing the following procedure, remove the direction switch board and the FF / REW lever assembly. 1. Remove the screw D attaching the playback head. 2. Remove the C washer and pull out the FF roller. 3. Remove the S support plate, the A arm spring (a) and (b), the playback head. ATTENTION: The A arm spring (a) differs from the A arm spring (b).
Removing the pinch-roller (R) and (F) assembly (See Fig.2)
Prior to performing the following procedure, remove the direction switch board and the FF / REW lever assembly. 1. Remove the P arm spring (f) in the pinch-roller (F) assembly from the chassis. 2. Remove the P arm spring (r) in the pinch-roller (R) assembly from the chassis. 3. Draw out the pinch roller (F) and (R) assembly from the shaft. ATTENTION: The P arm spring (f) differs from the P arm spring (r). ATTENTION: The pinch roller (F) assembly differs from the pinch roller (R) assembly.
1-9
|
|
|
> |
|
