|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
SOUND ADJUSTMENTS
Adjusting the sound
You can adjust the sound characteristics to your preference.
2
Adjust the level.
To increase the level.
1
Select the item you want to adjust.
Each time you press the button, the adjustable items change as follows:
To decrease the level.
(bass) (volume)
BAS
(treble) (loudness)
TRE
(fader) (balance)
FAD
VOL
LOUD
BAL
Note: Normally, the control dial works as the volume control. So you do not have to select �VOL� to adjust the volume level.
Indication
BAS
To do:
Adjust the bass.
Range
�06 (min.) | +06 (max.) �06 (min.) | +06 (max.) R06 (Rear only) | F06 (Front only) L06 (Left only) | R06 (Right only) LOUD ON | LOUD OFF 00 (min.) | 50 (max.)
Using the sound control memory
You can select and store a preset sound adjustment suitable for each playback source (Advanced SCM).
TRE
Adjust the treble.
FAD*
Adjust the front and rear speaker balance. Adjust the left and right speaker balance. Boost low and high frequencies to produce a wellbalanced sound at low volume level. Adjust the volume.
Selecting and storing the sound modes
Once you select a sound mode, it is stored in memory. It will be recalled every time you select the same source and will be shown on the display. A sound mode can be stored for each of the following sources � FM1, FM2, FM3, AM, tape and external components. � If you do not want to store the sound mode separately for each playback source, but want to use the same sound mode for all the sources, see �To cancel Advanced SCM � SCM LINK� on page 21.
BAL
LOUD
VOL
Select the sound mode you want.
Each time you press the button, the sound mode changes as follows:
* If you are using a two-speaker system, set the fader level to �00.�
BEAT
SOFT
POP
SCM OFF
17
ENGLISH
|
|
|
> |
|
