|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
As the only source for this manual it rather rank quite high since it is well scanned and perfectly readable.
 ;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
;
I received the Manual in a timely manner and it was exactly what I needed.
This is a perfect copy of the Service Manual, The quality is great. I am very
happy. Thank you
;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
KS-FX911/KS-FX811
REFERENCE: Prior to performing the following procedures, turn the mode gear on the bottom of the body until the respective part comes to the EJECT position (Refer to Fig.1).
Removing the reinforce bracket (See Fig.1 and 2)
1. Remove the screw A attaching the reinforce bracket on the bottom of the body. 2. To release joint a, turn and detach the reinforce bracket from the side bracket assembly as shown in Fig.2
Mode gear Reinforce bracket
A
Fig.1
Removing the cassette guide (See Fig.3)
1. Turn the mode gear to set to RVS play or subsequent mode. 2. Remove the cassette guide from the main chassis while releasing each two joint tabs b in the direction of the arrow.
Joint a
Reinforce bracket
Removing the head board (See Fig.4)
1. Remove the screw B on the upper side. Unsolder the wires on the under side of the head board, if necessary. REFERENCE: When reassembling, twist the wires by turning the head board twice remarked c and pass through the notch d as shown in Fig.4.
Fig.2
Head board
Soldering
B
Cassette guide
Head board notch d
Tab b
Tab b
c
Fig.3
Fig.4
1-7
|
|
|
> |
|
