|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good manual. Plenty of service information including alignment instructions. Clear circuit diagram. Excellent, thank you.
 ;
Good morning, the service manual you sent me was perfect.
Your service and answering are excellent.
I recomend this service.
Best regards.
;
I had been looking everywhere for a proper service manual for this VCR. Everywhere else that has this available for download has a very light version. This is the full service manual with all aspects that would interest anyone looking for the service manual for the AIWA HV-MX100 Worldwide VHS VCR. Great quality (as always). A winner hands down. Best Quality.
;
Top quality manual. Covers all aspects you'd expect in a top quality service manual for this Panasonic VHS VCR. The manual resolution is high. Another top quality manual from the only site worth downloading manuals from! If you're looking for a manual for the PV-9662 VHS VCR, this is the one you'll want to get!
;
complete part-lists and pcb layout, schematic diagram is good enlargable,
KS-FX922R
Removing the head relay board (See Fig.4)
1. Unsolder the soldering b on the head relay board. 2. Remove the screw C attaching the head relay board. 3. Remove the head relay board in the direction of the arrow while releasing the two joints c. Fig.4
Cach
Head relay board
Joint c
C
Soldering b
Removing the load arm (See Fig.5)
1. Remove the E washer attaching the load arm using a pincette or something like that and remove the spring d. 2. Move the part of the load arm marked upwards to release it from the axis of rotation. Then rotate the load arm in the direction of the arrow to remove it from the cach.
Load arm E washer Spring d
Fig.5
Removing the sub chassis (See Fig.6)
Prior to performing the following procedure, remove the head relay board. 1. Remove the screw D attaching the sub chassis. 2. Push the tab e in the direction of the arrow to detach the one side of the sub chassis. Then release the sub chassis from the tab f.
Tab f Tab e Head relay board
D
Fig.6
Reinforce bracket
Removing the cassette holder and the holder arm in the eject mode (See Fig.7 and 8)
Prior to performing the following procedure, remove the head relay board, the load arm and the sub chassis. 1. Remove the screw E attaching the reinforce bracket. 2. Remove the reinforce bracket. 3. Push the tab g fixing the cassette holder in the direction of the arrow and open the cassette holder and the holder arm upward until they stop at an angle of 45 degrees. Move the two joints h to the side and remove the cassette holder and the holder arm from the shaft.
Sub chassis
Cassette mecha chassis Cassette holder
E
Reinforce bracket tab g
Head relay board
Joint h
Load arm Holder arm
Joint h
Fig.7
1-7
|
|
|
> |
|
