|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This schema available for me in good condition. I would highly recommend.
;
Thanks for this "hard to find" service manual.
I apreciate the good quality of scanning and the pages scanned in A3 format.
;
Helpd me mont a new carradio when prewius mont was a mess.
;
Very good service and quick service, very good quality of service manual!
;
Great tape deck manual!
I'm very positively surprised, because it is a very long manual, lot of pages, drawings, diagrams, description of how to make the alignment and adjustment procedures.
It is as good as the old "Naka" manuals from the 1970's - if somebody have seen them, they know what I mean by that.
I recommend to buy this very much !
KV-25F3
3-2. CONVERGENCE
Preparation: � Before starting this adjustment, adjust the focus, horizontal size, and vertical size. � Minimize the brightness setting. � Provide a dot pattern.
�
Tilt the V.STAT magnet and adjust the static convergence by opening or closing the V.STAT magnet.
(1)
Horizontal and vertical static convergence
Center dot
R G B
4. If the V.STAT magnet is moved in the direction of the a and b arrows, the red, green, and blue points move as shown below.
RG
B
1
a b b
a
b
B G R
B G R
H.STAT
V.STAT Magnet
a
C Board RV701 SCREEN RV702
2
a R G B
1. (Moving horizontally), adjust the H.STAT control so that the red, green, and blue points are on top of each other at the centre of the screen. 2. (Moving vertically), adjust the V.STAT magnet so that the red, green, and blue points are on top of each other at the centre of the screen. 3. If the H.STAT variable resistor cannot bring the red, green, and blue points together at the centre of the screen, adjust the horizontal convergence with the H.STAT variable resistor and the V.STAT magnet in the manner given below. (In this case, the H.STAT variable resistor and the V.STAT magnet influence each other)
b b R G B
a 3 b a
b
R b G B
B G R
� 25 �
|
|
|
> |
|
