|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent copies.
I will use "Owner Manual" again a second time.
 ;
Very good manual for Technics SL 303. Manuale molto utile.
;
About one hour after checkout, the manual was available for download. Clear reading and detailed. Thanks
;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
KV-25X5
(4)
�
Screen corner convergence.
If you are unable to adjust the corner convergence properly, this can be corrected by the use of permalloy assemblies.
3-3. Screen [G2], White balance
G2 Setting
1. 2. 3. 4. Input a dot signal from the pattern generator. Set the Picture, Brightness and Colour to minimum. Apply 170Vdc from an external power supply to the R, G and B cathodes of the CRT. Whilst watching the picture, adjust the G2 control [RV701 SCREEN] located on the C Board to the point just before the flyback return lines disappear.
a a-d: screen-corner convergence defect c
b
d
White balance adjustment
1. 2. 3. 4. 5. Input a �PAL� all-white signal from the pattern generator. Enter into the Service Mode. Enter into the �Picture� service menu. Select the �Green drive� and adjust so that the White Balance becomes optimum. Select the �Blue drive� and adjust so that the White Balance becomes optimum. Set the Picture to MIN. Set the �R-cut-off� to 07. Adjust the �G-cut-off�, and the �B-cut-off� so that the White Balance becomes optimum. Press the button to return to TV operation.
Fit the permalloy assembly to the rear of the CRT to correct the area at fault.
a
6. 7. 8. 10.
b
PICTURE
R - Drive G - Drive Permalloy
c d
Adj Adj Adj Adj Adj Adj 02 01 01 Adj Adj Adj
B - Drive R - cut - off G - cut - off B - cut - off ID - start ID - stop ID - level Bellfo Sub Colour Sub Brightness
3-4. FOCUS
1. 2. 3.
FOCUS
Input a Phillips colour pattern Set the picture settings to normal. Adjust the focus control located on the Flyback transformer to bring the centre of the screen into focus. Note :Bring only the centre area of the screen into focus, switch to an all-white pattern and confirm that the magenta ring is hardly noticed. To obtain optimum focus balance the focus setting between optimum screen centre focus and a reduced magenta ring level.
19
|
|
|
> |
|
