|
There are currently no product reviews.
 ;
Acurate informations inside the SM and I could repair my old Sansui SC-3330 without any problems. Thanks.
;
I used it to repair a NAD 7030, but unfortunately, the 7045 is different !
But documentation was useful.
;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
;
Thanks you very much for this "hard to find" service manual.
Will help a lot in repairing this receiver.
Using the Timer
Menu
To access the Timer menu, use the following steps:
To Display To Highlight To Select
Timer Timer 1 : Set Timer 2 : Set Current Time
Move
Select
End
Current Time
Set your TV to the current day and time. Press to open the Current Time menu: 1 Use the F or f buttons to enter the correct day and time, then press . 2 Press to exit the menu.
�
You must set the Current Time before you can use Timer 1 or Timer 2.
Timer 1 and Timer 2 Scheduled viewing
Use the timers to program your TV to turn on and off by day, time, duration, and channel. The timer duration is a maximum of six hours. When the channel is fixed, it is not necessary to set the channel. 1 Use the F or f buttons to highlight Timer 1 or Timer 2, 2 then press . Use the F or f buttons to enter the desired day, start time, duration, and channel, then press . The timer status should be On when the Timer has been set, and the timer light on the front panel of the TV should be on. Press to exit the menu.
3
� �
Select Off to turn off the Timer. Your previous settings will be saved. When you perform Auto Program, Timer 1 and Timer 2 settings will be cleared. Also, in the event of any loss of power, Current Time, Timer 1, and Timer 2 settings will be cleared.
Menus
39
|
