|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent service and prompt delivery. But it's not a manual - only 4 pages wiring diagrams.
Thanks.
 ;
The manual I purchased was exactly what I needed to repair my Toshica television. The manual contained schematics and troubleshooting information that was very helpful.
;
Il download del Service Manual JVC HR 4100 non é stato eseguito
;
The Service Manual was just as expected, complete with schematics and I was able to download it in less than an hour after I ordered it. The only problem with these is that the schematics are hard to read due to the small font. I could remedy this by printing them on a larger printer.
;
Very fast, clear and usefull site !
Also this Service Manual are very well maked and with a very good definition !
Very fast download speed !
Recomended Seller !
3-3. SCREEN (G2)
LAYOUT OF EACH CONTROL
Purity magnet BMC (Hexaploe) magnet V STAT convergence magnet Y-splitting axis correction magnet
SCREEN G2 ADJUSTMENT
1. 2. 3. 4. Input a dot signal from the pattern generator. Set the Picture, Brightness and Colour to minimum. Apply 175V DC from an external power supply to the R, G and B cathodes of the CRT. Whilst watching the picture, adjust [SCREEN G2] located on the FBT [flyback transformer] to the point just before the flyback return lines disappear.
3-4. FOCUS
1. 2. 3 Receive a television broadcast signal. Normalise the picture setting. Adjust the focus control located on the FBT [flyback transformer] to obtain the best focus at the centre of the screen. Bring only the centre area of the screen into focus, the magenta-ring appears on the screen. In this case, adjust the focus to optimize the screen uniformly.
Fig 3-6 Note : If you are unable to adjust the corner convergence properly, this can be corrected with the use of permalloys.
a
b
a-d: screen-corner convergence defect c d
FOCUS
SCREEN (G2)
Permalloy Assy X-4387-214-1
Convergence adjustment with permalloy.
22
|
|
|
> |
|
