|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Complete service manual, was very helpful in repairing this tapedeck.Thanks.
;
The service manual was a copy of the original from Wirlpool. The quality was good, all neccecary information was available including the service-codenumbers, so I could order the right part to be replaced for repair.
Downloding was no probem after the payment.
Thanks for the service!
;
Good,readable manual. I found other manuals that were not readable when it came to part ID, but the one downloaded from owner-manual.com was better than expected. I will do buisness with owner-manual.com again.
;
Service Manual that I received was very helpful to me. Thank you.
;
The manual is well organized and is easy to read. The chapters are following normal way to proceed.
3-3. SCREEN (G2)
LAYOUT OF EACH CONTROL
Purity magnet BMC (Hexaploe) magnet V STAT convergence magnet Y-splitting axis correction magnet
SCREEN G2 ADJUSTMENT
1. 2. 3. 4. Input a dot signal from the pattern generator. Set the Picture, Brightness and Colour to minimum. Apply 175V DC from an external power supply to the R, G and B cathodes of the CRT. Whilst watching the picture, adjust [SCREEN G2] located on the FBT [flyback transformer] to the point just before the flyback return lines disappear.
3-4. FOCUS
1. 2. 3 Receive a television broadcast signal. Normalise the picture setting. Adjust the focus control located on the FBT [flyback transformer] to obtain the best focus at the centre of the screen. Bring only the centre area of the screen into focus, the magenta-ring appears on the screen. In this case, adjust the focus to optimize the screen uniformly.
Fig 3-6 Note : If you are unable to adjust the corner convergence properly, this can be corrected with the use of permalloys.
a
b
a-d: screen-corner convergence defect c d
FOCUS
SCREEN (G2)
Permalloy Assy X-4387-214-1
Convergence adjustment with permalloy.
22
|
|
|
> |
|
