|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good service manual,i saved from scrapping this deck,is now fully functional.Thanks.
 ;
Found this to be the manual included with the original packinging, was helpfull but did not give any detailed repair instructions.
;
Complete service manual, was very helpful in repairing this tapedeck.Thanks.
;
The service manual was a copy of the original from Wirlpool. The quality was good, all neccecary information was available including the service-codenumbers, so I could order the right part to be replaced for repair.
Downloding was no probem after the payment.
Thanks for the service!
;
Good,readable manual. I found other manuals that were not readable when it came to part ID, but the one downloaded from owner-manual.com was better than expected. I will do buisness with owner-manual.com again.
KV-28WF1
2-7. PICTURE TUBE REMOVAL
�
REMOVAL OF ANODE-CAP
carbon paint on the CRT, after removing the anode.
Note: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or 6 Two DGC holers 7 Degaussing coil 8 Spring extension
* REMOVING PROCEDURES. c
a
b b
Anode button
1 Turn up one side of the rubber cap in the direction indicated by the arrow a
3 C board 4 Neck assy 2 Chassis assy
2 Using a thumb pull up the rubber cap 3 When one side of the rubber cap is firmly in the direction indicated by the separated from the anode button, the arrow b anode-cap can be removed by turning up the rubber cap and pulling it up in the direction of the arrow c
�
1
2 3
9 Four PT screws 5 Deflection yoke
HOW TO HANDLE AN ANODE-CAP Don't damage the surface of anode-cap with sharp shaped material ! Don't press the rubber hardly not to hurt inside of anode-caps ! A metal fitting called as shatter-hook terminal is built into the rubber. Don�t turn the foot of rubber over hardly ! The shatter-hook terminal will stick out or damage the rubber.
22 �
1 Anode cap 10 Picture tube
Cushion
|
|
|
> |
|
