|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I needed a service manual as the display on my oscilloscope was very dim. I thought I'd give owner-manuals.com a try, as they advertised a huge number of manuals. Sure enough they had one listed. I bought it hoping it would be useful... actually, I bought it hoping it would be readable! I've had manuals from online sources in the past, and been very disappointed. Not this time! An excellent manual, complete, and very readable. Using it I fixed my 'scope, and as such the manual was an investment that paid off manyfold. Do I have any complaints? One very minor one - The circuit diagrams could have been scanned at a higher resolution, as some of the details were a little difficult to make out - not impossible, just not as easy as my old eyes would like! Overall, I'm very satisfied with my manual, and I will certainly be using this company again. Well done.
 ;
I Have looked for this manual for quiet a while now, I have finally found it here. I believe this is the only place they have them in a very nice scan, pages are very clear to read, some of the pages are a bit tilted but overall it is great to have this manual available for purchase. Thanks
;
This is quiet a rare manual, I Have looked for this manual for quiet a while now, I have finally found it here. I believe this is the only place they have them in a very nice scan, Excellent guide: very clear, enabling us to print readable diagram overall it is great to have this manual available for purchase. This is a complete service manual no pages are missing. Thanks
;
This SM is quiet scarce and hard to find it is an excellent Service manual, very clear to read and to print schematics and diagrams, Hi quality, Complete manual with no pages missing. I am very pleased with the manual and the fast service I have received. Great place to shop.
Good luck finding you manual...
;
Quick delivery, the document was usefull, although the copy was i little bit unclear in the details.
FE-1A SELF DIAGNOSTIC SOFTWARE
The identification of errors within the FE-1A chassis is triggered in one of two ways :- 1: Busy or 2: Device failure to respond to IIC. In the event of one of these situations arising the software will first try to release the bus if busy (Failure to do so will report with continuous flashing LED) and then communicate with each device in turn to establish if a device is faulty. If a device is found to be faulty the relevant device number will be displayed through the LED (Series of flashes which must be counted) See Table 1., non fatal errors are reported using this method. Each time the software detects an error it is stored within the NVM. See Table 2.
Table 1
ERROR No error Not allowed (may be confused with Sircs response flash!) Protection circuit trip < ANY TIME > Reserved No vertical sync AKB IIC bus clock and/or data lines low at Power ON NVM no IIC bus acknowledge at Power ON Jungle controller no IIC acknowledge at Power ON Tuner no acknowledge at Power ON Sound processor no acknowledge at Power ON LED ERROR COUNT 00 01 02 03 04 05 06 07 08 09 10
How to enter into Table 2
1. 2. Turn on the main power switch of the TV set and enter into the �Standby Mode�. Press the following sequence of buttons on the Remote Commander.
i+
(ON SCREEN DISPLAY)
5
(DIGIT 5) (VOLUME -) (TV)
3.
The following table will be displayed indicating the error count.
Table 2
Error Times -
Flash Timing Example : e.g. error number 3
StBy LED ON ON ON
2 3 4 5 6 7 8 9 10
OFF
OFF
Note: To clear the error count data press �80� on the Remote commander.
6
|
|
|
> |
|
